|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
04-07-2010, 11:46 AM | #1 |
Not Yet Wild
Join Date: Apr 2010
Posts: 2
|
1992 Series EZ-GO parts location?
We have a 1992 Series EZ-Go Electric golf cart. We have a problem with the acceleration in that it just starts at full throttle. When the peddle is pressed down (either reverse or forward) it jumps to full speed and doesn't have any control other than that. Can someone please help us with locating the Inductive Throttle Sensor (ITS) on this cart? We're sort of newbies to this. Thank you in advance.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-07-2010, 01:01 PM | #2 |
Gone Wild
Join Date: Nov 2009
Location: Pennsylvania
Posts: 167
|
Re: 1992 Series EZ-GO parts location?
Here's how to access the pedal box where the ITS is located.
|
04-07-2010, 02:31 PM | #3 |
Not Yet Wild
Join Date: Apr 2010
Posts: 2
|
Re: 1992 Series EZ-GO parts location?
Free Spirit, Thanks for the input. I'm helping a neighbor repair his EZ-GO cart. Upon initial trouble shooting I found a broken 250 ohm resistor which is sitting across the large terminals of the Solenoid. I'm not sure what the purpose of this resistor is, but we are in the process of getting a replacement. we aren't sure if replacing the 250 ohm resistor will cure this problem, but it probably should be replaced, so we will replace it.
I've been reading many of the posts about the EZ-GO carts and it seems that possibly there are two versions of the 1992 Series carts. One having a Inductive Throttle Sensor (ITS) and one with possibly a resistive network of some sort. Not being sure just which we have until we get into it further...we'll keep at it till we figure it out. Thanks again for your input. Deamer1 |
04-07-2010, 06:01 PM | #4 |
steeplejack x
Join Date: Jan 2007
Location: Republic of Texas
Posts: 3,382
|
Re: 1992 Series EZ-GO parts location?
A 1992 doesn't have an ITS. It will either be a potentiometer in a controller cart or a speed board if it's a resistor cart.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Taylor - Dunn Vin# Location? | Gas golf carts | |||
01 workhorse ignitor location | Gas EZGO | |||
6x6V series or 2x3x12V Series/parallel | Electric golf carts | |||
parts for my 1992 g8 | Golf Carts and Parts |