|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
03-28-2013, 06:15 PM | #1 |
Getting Wild
Join Date: Aug 2010
Location: PR
Posts: 105
|
Help!!! Click, no go, new batt '96, 48v
Hi guys, lomg time...
I placed two years ago new solenoid, altrax controller and last year new obc. 6 months ago batteries went bad, I waited until last week to purchase the full 8v pack. Installed, charged them, 50.1volts from full pack, click on the solenoid, but it wont move.... I jumped the two poles from the solenoid, v swith to fwd, and pressed pedal, still hear the click, but it wont move at all. (Btw, cart was on towers, in case it move, it would ran me over ;) ) Any suggestions. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-28-2013, 06:20 PM | #2 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: Help!!! Click, no go, new batt '96, 48v
96 series cart, solenoid clicks, 50v, no go.... maybe the F&R contacts are bad or a cable connection is bad? Are you getting a solid green light on the control when you try to go? If not, then what color & count of blinking lights?
|
03-28-2013, 08:41 PM | #3 |
Getting Wild
Join Date: Aug 2010
Location: PR
Posts: 105
|
Re: Help!!! Click, no go, new batt '96, 48v
Hey Scottyb, thank you for fast reply.
Controller is blinking 7 times in fwd and 7 times in reverse. Green led |
03-28-2013, 08:44 PM | #4 |
Getting Wild
Join Date: Aug 2010
Location: PR
Posts: 105
|
Re: Help!!! Click, no go, new batt '96, 48v
LED Status Indicator:
and used for troubleshooting. The LED Blink Codes occur at power up, the number of green blinks indicates the throttle configuration: * 1 Green LED flash ***= 0-5 kohm resistive 2 Green LED flashes = 5K-0 ohm resisitive 3 Green LED flashes = 0-5 Volt 4 Green LED flashes = EZ-GO inductive (ITS) 5 Green LED flashes = Yamaha 0-1K ohm resistive 6 Green LED flashes = Taylor-Dunn 6-10.5 Volt 7 Green LED flashes = ClubCar 5k-0 ohms, 3-wire throttle Normal display status: ***** Solid Green: Controller ready to run Solid Red: Controller in programming mode (using Controller Pro) Solid Yellow: *Controller throttle is wide open, controller is supplying max output, and is not in current limit. Trouble Shooting: Error code display:# of RED blinks ***indicates any error conditions that might exist: 1 Red *= *Throttle Position Sensor Over Range. *Check for open wires. 2 Red *= *Under Temperature. *Controller below -25C 3 Red *= *HPD. *Throttle hasn't gone to zero during this power on cycle. 4 Red *= *Over Temperature. *Controller over 95C 5 Red *= *Not used 6 Red *= *Battery Under Voltage detected. *Battery V < under voltage slider 7 Red *= *Battery Over Voltage detected. *Battery V > over voltage slider |
03-28-2013, 08:45 PM | #5 |
Getting Wild
Join Date: Aug 2010
Location: PR
Posts: 105
|
Re: Help!!! Click, no go, new batt '96, 48v
What does it means:
7 Green LED flashes = ClubCar 5k-0 ohms, 3-wire throttle |
03-28-2013, 09:30 PM | #6 |
Getting Wild
Join Date: Aug 2010
Location: PR
Posts: 105
|
Re: Help!!! Click, no go, new batt '96, 48v
Note: just curious, after the blinking, led shuts off, even if the pedal still pressed.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
RXV 2009 click click but won't move | Electric EZGO | |||
No click, click, when I hook up my charger? | Electric Club Car | |||
Number of batt. | Electric Club Car | |||
Click Click - will not move ! | Electric EZGO | |||
12v batt question | Electric EZGO |