1998 club car ds Ignition coil question kawasaki fe290

[mstone80]

A mechanic installed a kill switch on my cart years ago. The wire came loose and i cant find where it was hooked up. Its the black/white wire from the ignition coil. Where does it connect? What too? The wire from coil went to switch and then a wire from switch to somewhere but im not seeing where. I grounded it and nothing, hooked it to positive and nothing. Hooked it to a microswith and nothing. I am at a loss. I am removing the ghetto *** kill switch and hooking it up like its supposed to be. Please help.

[CP241]

Where are you located in south GA?

This may help. If not you may be close to me http://www.buggiesgonewild.com/attac...1&d=1570824822

[mstone80]

Adel ga. Thx

[CP241]

Originally Posted by mstone80

Adel ga. Thx

I'm near jesup, not too far from you. If the diagram doeant help and you cant figure it out give me a shout and I'll help you out

[mstone80]

The diagram doesnt help because it dosent show the ignition coil. I know the 1 wire goes to spark plug but there is a black wire with a white stripe that goes from coil to somewhere.

[CP241]

It is 1 black/white wire that runs to the bullet connector next to the rev limiter. It runs from there to the microswitch inside the black electronics box next to the air box.

[mstone80]

My rev limiter has been bypassed so i dont know how it should wire up the bottom microswitch in box only has 1 wire going to it. It rigged up. I just want the thing to crank. I mainly just ride around fields and stuff. Its just a runaround cart. Dont take it far and dont drive fast