|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
08-13-2020, 02:32 PM | #1 |
Not Yet Wild
Join Date: Aug 2020
Location: NE NC
Posts: 26
|
2008 YDRE no clicks, no movement. Reed switch?
Problem started with stopping while driving, flipping the run/tow switch would get it going again. Now the backup buzzer works but no movement and no clicking from the solenoid. Best I can tell there is no ground at the solenoid. I know EZGO carts have reed switches not sure about Yamahas. But from the research I've done, that could be the problem.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-13-2020, 03:46 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: 2008 YDRE no clicks, no movement. Reed switch?
No "reed switch" on a yamaha YDRE.
|
08-14-2020, 04:45 AM | #3 |
Not Yet Wild
Join Date: Aug 2020
Location: NE NC
Posts: 26
|
Re: 2008 YDRE no clicks, no movement. Reed switch?
|
08-14-2020, 04:59 AM | #4 |
Not Yet Wild
Join Date: Aug 2020
Location: NE NC
Posts: 26
|
Re: 2008 YDRE no clicks, no movement. Reed switch?
I'm learning a lot by searching this site. I Need to check the solenoid ground with the pedal depressed. That's not the way I was testing.
|
08-15-2020, 07:40 AM | #5 |
Not Yet Wild
Join Date: Aug 2020
Location: NE NC
Posts: 26
|
Re: 2008 YDRE no clicks, no movement. Reed switch?
No ground at the solenoid with the pedal depressed. What does the 3rd wire on the charging receptacle do? What do I need to check next?
|
08-15-2020, 08:44 AM | #6 |
Not Yet Wild
Join Date: Aug 2020
Location: NE NC
Posts: 26
|
Re: 2008 YDRE no clicks, no movement. Reed switch?
I've been following hoggin03's thread. My stop switch checks good. But I have only 5 volts at my pedal.
|
08-17-2020, 06:35 AM | #7 |
Not Yet Wild
Join Date: Aug 2020
Location: NE NC
Posts: 26
|
Re: 2008 YDRE no clicks, no movement. Reed switch?
Still hoping for some help.
|
08-17-2020, 08:13 AM | #8 |
Gone Wild
Join Date: Sep 2010
Location: Florida
Posts: 1,895
|
Re: 2008 YDRE no clicks, no movement. Reed switch?
Try going through this checklist...sorry it’s sideways lol
|
08-17-2020, 10:22 AM | #9 |
Not Yet Wild
Join Date: Aug 2020
Location: NE NC
Posts: 26
|
Re: 2008 YDRE no clicks, no movement. Reed switch?
|
08-17-2020, 10:45 AM | #10 |
Gone Wild
Join Date: Sep 2010
Location: Florida
Posts: 1,895
|
Re: 2008 YDRE no clicks, no movement. Reed switch?
Most often yes...I have seen the solenoid not work if the motor has a short as well though, hard to tell without taking motor out and checking brushes but you can ohm between motor terminals...should have continuity between two A terminals and Two F terminals but not between each other...such as meter on F1 and A1 should not show continuity but F1 and F2 should...this is without wires going to it of course...If motor checks out I would say your controller has failed
|
|
|
Similar Threads | ||||
Thread | Forum | |||
If solenoid clicks can reed be bad? | Electric EZGO | |||
2008 YDRE: Many clicks, but no go | Electric Yamaha | |||
2008 YDRE will not switch into reverse | Electric Yamaha | |||
Ydre xct500 install no movement or buzzer | Electric Yamaha | |||
1988 Five Clicks with no movement | Electric Club Car |