|
06-11-2013, 03:56 PM
|
#1 |
|
Gone Wild
Join Date: Dec 2010
Posts: 635
|
Valve collets EZ GO
can someone tell me how to put collets on the valve stem on a ez go gas when trying to do the i keep dropping the valve
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
06-11-2013, 04:36 PM
|
#2 |
|
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: Valve collets EZ GO
1. You can use compressed air into the spark plug hole to hold the valve up.
or 2. If the keepers are already off the valve, use a zip-tie to hold the valve up. Remove the spark plug and put the piston all the way to the bottom. Take about 3 feet of nylon clothes line and put as much of it into the spark plug hole as possible. Make sure you don't lose the end of it. Raise the piston. This will push the clothes line up and hold the valve in place while you install the keepers. Lower the piston and remove the clothes line. Put a little bit of grease on the keepers. That way you won't drop them. |
|
|
|
|
06-11-2013, 05:16 PM
|
#3 |
|
Getting Wild
Join Date: May 2013
Posts: 137
|
Re: Valve collets EZ GO
^^ yes, everything is perfect [/thread]
|
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| briggs vtwin valve oil seal which valve | Big Block Talk! | |||
| Looking for valve seats | Gas EZGO | |||
| 98 Marathon Valve Job | Gas EZGO | |||
| 97 Ez-Go Valve kit | Gas EZGO | |||
| valve job | Gas Yamaha | |||
Linear Mode
