09-26-2013, 09:24 AM | #1 |
Not Yet Wild
Join Date: Apr 2013
Posts: 64
|
new thread?pully size
Hey Lou,and anyone else,my new s/g has a smaller diameter pully than the old s/g.The belt groove is the same but if I put on the old pully I can only get a couple of turns on the nut and no lock washer.Any ideas? Thanks
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-27-2013, 06:51 AM | #2 |
Gone Wild
Join Date: Feb 2011
Posts: 1,515
|
Re: new thread?pully size
If you look at your old s/g remove the woodruff key then you'll find a spacer. Do the same to the new one and see if they are the same size (length) you may have to use the old spacer on the new s/g to get the spacing correct. Report back
LOU |
09-27-2013, 07:42 AM | #3 |
Not Yet Wild
Join Date: Apr 2013
Posts: 64
|
Re: new thread?pully size
OK,so the old s/g has 3 screws that hold the cover to get to the spacer,the new s/g doesn't have those screws,it looks like the rear cover is held on by a snap ring.I've tried using a small piece of wire to get to the ear on the snap ring but there isn't enough room between the armature and the rear cover to get it off,so I'm thinking that that ring doesn't hold the rear cover on.I tried tapping the cover with a hammer but don't want to go to hard on that cast aluminum plate.Whats my next step?Thanks!!!
|
09-28-2013, 10:09 AM | #4 |
Gone Wild
Join Date: Feb 2011
Posts: 1,515
|
Re: new thread?pully size
Look close on the pulley end of the armature you don't have to do anything but remove the pulley and woodruff key the spacer just slides over the armature shaft. Post a pic if you can't figure it out OK???
|
09-28-2013, 11:21 AM | #5 |
Not Yet Wild
Join Date: Apr 2013
Posts: 64
|
Re: new thread?pully size
OK gotcha,the hew s/g doesn't have a spacer.My old pulley won't slide in far enough to put on the lock washer and nut,I can only get 2 turns on the nut and that's without the washer.Any problem using the new pulley witch is a 1/2" smaller diameter? The grove for the belt is the same size and the overall length with new pulley on is the same as the old set-up.Thanks
|
|
|
Similar Threads | ||||
Thread | Forum | |||
thread size? | Electric Yamaha | |||
Need Help with Bolt Size and Thread | Gas EZGO | |||
Clutch thread size ? | Gas EZGO | |||
Comet Clutch Puller Thread size?? | Gas Yamaha | |||
What size thread for Primary Puller Bolt? | Gas Yamaha |