04-22-2011, 08:59 AM | #1 |
Getting Wild
Join Date: Feb 2011
Location: Boonville Indiana
Posts: 109
|
Camshaft
How do ya remove the camshaft? and do i need a new seal?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-22-2011, 12:04 PM | #2 |
Gone Wild
Join Date: May 2008
Location: Netherlands (Europe)
Posts: 170
|
Re: Camshaft
Hello Doozerann,
Put everything on their marks: cranck and camshaft. Loosen up the bolts in the rockers til everything is free. Loosen the bolt on the camshaftwheel and take the wheel off Take the plate at the side of. Now you can take the camshaft out. Building it in: Get the cranckshaft, lubricate the "bearings" and put it in, so the marks are in the right place. Be sure you did not turn the engine while take it out or in. Check the marks on the cranck and the camshaft. Get the right valveclearance, i use 0.10 mm inlet and 0.15 outlet Turn the engine with your hand to be sure you didnt move enything. Than fire it up... Benno |
04-22-2011, 01:03 PM | #3 |
Getting Wild
Join Date: Feb 2011
Location: Boonville Indiana
Posts: 109
|
Re: Camshaft
Thanks Benno, I got it out no problems
|
|
|
Similar Threads | ||||
Thread | Forum | |||
High Performance EH29 - EH35 ezgo cam camshaft | Gas EZGO | |||
Vanguard Camshaft Modifications | Big Block Talk! | |||
23hp briggs camshaft loose | Big Block Talk! | |||
Stock vs hot camshaft | Gas EZGO | |||
Yamaha G9 camshaft bearings | Gas Yamaha |