Where to find a roll cage for a EZGO

[Springlake]

Originally Posted by kgsc

Brandon is a good guy but watch out for Collin

The top tubes on mine are tucked in so you don't bash your head getting in and out and also so the factory top could rest on them.. I don't remember the measurements but I will try to get them this weekend.

Ken
Brandon asked me to measure. Especially the height. He is working on handles too, If you can, see what your ground to top measure is/ and clearence from floorboard. Thanks!
I noticed today bringing in the gasser that I need to take in to account the height of my garage. With the lift I might need a bit lower top and still not hit my hard head

[kgsc]

Will do. The one I have is probably an inch or two too low. It is fine for me at 5'11" but my buddy is 6'4" and he has to slump a little. I will measure as many ways that I can think of. As for overall height, her's has 22" tires with a factory 4" lift and door clearance is not an issue

[kgsc]

OK, I'm an idiot.. Got to the lake place to realize I didn't have a tape measure Pretty sure I'm going up next weekend and will throw one in the truck today so I don't forget..

[DaveTM]

Wait???....were we talking top tubes???....or tube tops?????

[kgsc]

I will be happy to measure either ..

[Springlake]

Originally Posted by kgsc

OK, I'm an idiot.. Got to the lake place to realize I didn't have a tape measure Pretty sure I'm going up next weekend and will throw one in the truck today so I don't forget..

Ken, No Prob. We r going in the fall anyway. I did a prelim on mine after I got her back together. It looks like 6'1" overall.Not including the top thickness. I'll wait to get your measures. look into back bars height off the frame and front, and overall height from the ground, please.. the spacing of your bars on the top would be nice. I going to try and use my same windshield we think,
I will probably attach that perminent.

[kgsc]

This is on a workhorse but I will try to measure everything that would be common. Bar height from the floor and seat, front to rear spacing and width, front and rear tube spacing and depth.. and whatever else I can think of..

Kris

[Springlake]

Originally Posted by kgsc

This is on a workhorse but I will try to measure everything that would be common. Bar height from the floor and seat, front to rear spacing and width, front and rear tube spacing and depth.. and whatever else I can think of..

Kris

Thanks Kris, Sorry for calling you Ken. Old age has its dis advantages!!

[Motor1]

Heck make one yourself it is a great experience. I made mine out of 1-1/4" Aluminum tubing and used a conduit hand bender. This was a first time with a tig welder and what a time I had.

[kgsc]

Very nice.. I like the mounting idea.. Protects the sides as well..