|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
07-19-2013, 07:02 AM | #1 |
Not Yet Wild
Join Date: Oct 2010
Location: Long Island,NY
Posts: 32
|
Carb Float Level
Greetings, does any know what the proper float level spec is on a G9 carb??
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-19-2013, 07:52 AM | #2 |
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: Carb Float Level
Could be wrong, but I think float should be level with the mating surface of the bowl, when inverted. (lateral with the bowl surface).
|
07-19-2013, 08:23 AM | #3 |
Not Yet Wild
Join Date: Oct 2010
Location: Long Island,NY
Posts: 32
|
Re: Carb Float Level
I'm looking 4 the factory measurement. Perhaps around 15-18mm or something in that range, but I'm not too sure. I just sent out a new post discussing my fuel starvation problem and I went through a list of possibilities but still coming up empty.
|
07-19-2013, 08:37 AM | #4 |
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: Carb Float Level
So will it sit and idle at low speed. But will not run in the mid ranges?
If that is the case, then jet and emulsion tube is clogged up. Thats where I'd be looking. And is the float chamber still full of gas when you pull the bowl off? This tells you the carb is getting gas, but carb can't deliver it in the upper ranges. (high speed circuit) |
07-19-2013, 11:06 AM | #5 |
Not Yet Wild
Join Date: Oct 2010
Location: Long Island,NY
Posts: 32
|
Re: Carb Float Level
Yeah when I rev it up, it starts dying out pretty quick, although the gas line is full of gas. I hadn't removed the bowl when it conks out, that's a good idea. Yesterday when I tore down the carb it did have some gas in it and it was very clean. No obstructions what so ever. Went thru each jet and crevices completely. What was weird when I stripped it down, there wasn't a wire clip attached between the needle and the float. The original carb had it, but this one year old carb does not. I'm not sure if it's a revised Mukuni carb or not.
|
07-19-2013, 06:58 PM | #6 |
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: Carb Float Level
Man, I don't know. Need pictures
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G1 float level setting | Gas Yamaha | |||
float level | Gas EZGO | |||
ST-480 2001 Start/stall problem Float Level? | Gas EZGO | |||
G1 - Carb Float? | Gas Yamaha | |||
What float level for flat head? | Gas Club Car |