|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
06-22-2022, 07:44 PM | #291 |
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,495
|
Re: Installing HEI Ignition on 3PG Carts
Half volt is correct.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-12-2023, 07:18 PM | #292 |
Not Yet Wild
Join Date: May 2021
Posts: 4
|
Re: HelpI keep frying the ignitor in my HEI conversion
|
04-13-2023, 09:04 AM | #293 | |
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,495
|
Re: HelpI keep frying the ignitor in my HEI conversion
Quote:
You could also try a different module. Some are better than others. I have had the same Accell since 2013. |
|
04-13-2023, 10:08 AM | #294 |
Gone Wild
Join Date: May 2011
Location: Pittsburgh
Posts: 2,943
|
Re: Installing HEI Ignition on 3PG Carts
Although I have never done an HEI conversion on an EZ Go I have done a bunch on old Columbias and Harleys. You may have too much current in your ignition circuit which will cause the "too much heat" thing as well. You can try installing a ballast resistor or two between the HEI module and the ignitor / coil to take some of that current out. I normally use 1.5 ohm resistors but have gone as high as 2.5 ohm.
|
05-30-2023, 08:30 AM | #295 |
Not Yet Wild
Join Date: May 2023
Location: Minnesota
Posts: 4
|
Re: Installing HEI Ignition on 3PG Carts
I did this swap on my cart and it goes fine but now it backfires... does anyone have any suggestions? thank you!
|
06-01-2023, 01:54 PM | #296 | |
Gone Wild
Join Date: May 2011
Location: Pittsburgh
Posts: 2,943
|
Re: Installing HEI Ignition on 3PG Carts
Quote:
Make sure that your throttle lever closing all the way when the accelerator pedal is at rest as to prevent fuel from flowing without ignition. If you have a way to adjust when spark starts / stops you may want to try adjusting to start spark earlier as well. Without knowing your specific cart, there's normally a microswitch somewhere that will activate with the accelerator pedal. Those can usually be adjusted. |
|
06-13-2023, 09:38 PM | #297 | |
Not Yet Wild
Join Date: May 2023
Location: Missouri
Posts: 65
|
Re: Installing HEI Ignition on 3PG Carts
Quote:
|
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Top Notch Carts, Edinburgh, Indiana. Carts I've built. | Members Rides | |||
Yamaha G9-Ignition Coil & Ignition Switch-Help | Gas Yamaha | |||
Installing a DCX 400 | Electric EZGO | |||
Carts, carts, carts!!!-'01 EZ GO-$1300.00!!?? | Golf Carts and Parts | |||
Installing Light Kit G16 | Gas Yamaha |