|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
03-31-2019, 07:11 PM | #1 |
Not Yet Wild
Join Date: Mar 2018
Posts: 60
|
G16 Hesitates when pushing gas
Wondering why about 25% of the time when I push the gas my cart makes humming noise and takes about 5 seconds to take off. It does it bad after I wash it.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-31-2019, 09:49 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: G16 Hesitates when pushing gas
Starter/generator belt is loose, or worn out. It's an easy adjustment.
|
03-31-2019, 09:53 PM | #3 |
Not Yet Wild
Join Date: Mar 2018
Posts: 60
|
Re: G16 Hesitates when pushing gas
Yea that’s where I was leaning. Would getting being worse after I wash it be same thing?
|
03-31-2019, 10:00 PM | #4 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: G16 Hesitates when pushing gas
Do loose belts slip worse when they are wet? I would say yep.
|
03-31-2019, 10:06 PM | #5 |
Not Yet Wild
Join Date: Mar 2018
Posts: 60
|
Re: G16 Hesitates when pushing gas
Good point! Lol. Appreciate it!
|
03-31-2019, 10:18 PM | #6 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: G16 Hesitates when pushing gas
12mm nut for top "lock nut", loosen 17mm pivot bolt at bottom of starter generator. 10mm bolt to do the adjustment for you. Don't go too tight either, it will make bearings noisy/fail sooner. A old, worn motor sounds like a can of rocks if you over tighten the belt.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
pushing race car | Gas Yamaha | |||
Pushing a cart | Electric EZGO | |||
delay when pushing gas | Gas Yamaha | |||
Have to keep pushing choke to run | Gas Club Car | |||
towing/pushing | Electric Yamaha |