|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-13-2019, 06:57 AM | #1 |
Not Yet Wild
Join Date: Feb 2009
Posts: 10
|
EZGO 2014 RXV 3” Lift Kit
I have put a Jake’s 3” lift kit on my cart and need some advice. The lift appears to be installed correctly according to Jake’s instructions. The problem is when I try to jack the cart from the rear axel the axel raises and not the body of the cart. Therefore I cannot raise the rear of the cart to install the rear tires. If I could install the tires I believe the axel gearbox will foul on the under body. I have been talking with Jake’s but so far no luck. Any help would be greatly appreciated.
Thanks, John Last edited by golfunguy; 07-13-2019 at 07:20 AM.. Reason: Add photo |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-13-2019, 07:01 AM | #2 |
Gone Wild
Join Date: Jul 2018
Location: Central Ohio
Posts: 1,720
|
Re: EZGO 2014 RXV 3” Lift Kit
If you can post some pictures of the connection points, of the lift components, that would probably make for a quicker diagnosis.
|
07-13-2019, 08:18 AM | #3 |
Gone Wild
Join Date: Sep 2018
Location: Md.
Posts: 1,059
|
Re: EZGO 2014 RXV 3” Lift Kit
Might be angle of picture but is the U clamp tight?
Looks like it’s not holding axle tight to mount😊 |
07-13-2019, 08:41 AM | #4 | |
Gone Wild
Join Date: May 2016
Location: Central Alabama
Posts: 1,048
|
Re: EZGO 2014 RXV 3” Lift Kit
Quote:
Also, I do not think the 3" kit has the block spacer you show, yours looks more like a 6" lift. I am going from memory, but I think your pic looks different than the last RXV 2014 lift kit I did. Not sure this pic is accurate, but this is what Jake's shows: https://www.jakesliftkits.com/liftki...-2014-up)/7504 looking closer, comparing the two links below, it looks like you have a 6" kit and it appears to be the one for the GAS rxv. https://www.jakesliftkits.com/liftki...-2014-up)/7505 https://www.jakesliftkits.com/liftki...-2014-up)/7506 |
|
07-13-2019, 08:58 AM | #5 |
Not Yet Wild
Join Date: Feb 2009
Posts: 10
|
Re: EZGO 2014 RXV 3” Lift Kit
Yes it’s as tight as it will go. There is gap between the axel and lift block but there is a plate on the bottom so it will only tighten up to the lift block no more.
|
07-13-2019, 09:30 AM | #6 | |
Not Yet Wild
Join Date: Feb 2009
Posts: 10
|
Re: EZGO 2014 RXV 3” Lift Kit
Quote:
|
|
|
|
Similar Threads | ||||
Thread | Forum | |||
2014 TXT lift | Electric EZGO | |||
2014 TXT lift kit | Electric EZGO | |||
Scraping / grinding sound in rear - deceleration / lift off throttle 2014 EZGO TXT48 | Electric EZGO | |||
Jakes 6” lift up on 2014 and up RXV | Electric EZGO | |||
2014 RXV with Ezgo lift - rear wheel spacers | Electric EZGO |