|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
04-21-2009, 04:31 PM | #1 |
Gone Wild
Join Date: Dec 2007
Posts: 391
|
Golf Ball Hole Cover and dash changes
Previous owner must have had a radio in the golf ball holder. The opening was cut up and looked bad. I made a cover plate out of black ABS plastic sheet I got off ebay. I think the size is 2 1/2" x 7 5/8". It was easy to make.
The previous owner also put the light switch next to the key so I relocated it to the tee holder. Also got a new switch plate cover to make the plate look like it was new. I don't like the screws that are holding the plate in place. Does anyone know what the originals looked like? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-21-2009, 06:40 PM | #2 |
Getting Wild
Join Date: Mar 2009
Location: Middle Ga.
Posts: 91
|
Re: Golf Ball Hole Cover and dash changes
Good job on making the cover. As for the fastners, I went to Harbor Freight and bought some black nylon riviots that makes it look factory......at least to me it does.
|
04-22-2009, 03:56 PM | #3 |
Gone Wild
Join Date: Apr 2009
Location: indiana
Posts: 274
|
Re: Golf Ball Hole Cover and dash changes
those rivets should be 1/8' or 3/16" push rivets, never really seen the push rivets untill i started to work on ezgos, but any black snap rivet will work and nobody will ever know the diff
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
golf ball in gas tank | Gas Yamaha | |||
Anyone have ball holder cover ideas? | Gas EZGO | |||
radio install in golf ball holder | Electric EZGO | |||
Golf cart stalls after going through mud hole. | Gas EZGO | |||
Dash cover will not cover | Gas EZGO |