|
Gas Club Car Gas DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
06-08-2013, 02:22 PM | #11 |
Not Yet Wild
Join Date: Jun 2013
Posts: 10
|
Re: Help,Engine Starts no movement 1992 Gas CCar
No spark,
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-08-2013, 07:16 PM | #12 |
Photoshop Guy
Join Date: Aug 2012
Location: Canal Fulton, OH
Posts: 3,845
|
Re: Help,Engine Starts no movement 1992 Gas CCar
If its no spark and everything is hooked up it could be your ignition coil.
|
06-08-2013, 11:16 PM | #13 |
Not Yet Wild
Join Date: Jun 2013
Posts: 10
|
Re: Help,Engine Starts no movement 1992 Gas CCar
Thanks for all the replies Springbok,
Can an ignition coil work and fail and work..? |
06-09-2013, 07:23 AM | #14 |
Photoshop Guy
Join Date: Aug 2012
Location: Canal Fulton, OH
Posts: 3,845
|
Re: Help,Engine Starts no movement 1992 Gas CCar
As the coil gets weaker there could be a stage where it gets intermittent. But eventually it will stop altogether. Make sure all your connections are good.
|
06-11-2013, 05:10 AM | #15 |
Gone Wild
Join Date: Jun 2008
Location: Austin, Tx area
Posts: 209
|
Re: Help,Engine Starts no movement 1992 Gas CCar
|
06-11-2013, 06:38 AM | #16 |
What the ....?
Join Date: Jan 2007
Location: N.E. Wisconsin
Posts: 14,901
|
Re: Help,Engine Starts no movement 1992 Gas CCar
A 1992 should have an FE290 OHV engine, and the ignitor was separate from the coil from 92 to 96 in most FE290's,
The ignitor would be my first suspect! http://www.cartpartsplus.com/ignitor-92-96 |
06-11-2013, 01:08 PM | #17 |
Not Yet Wild
Join Date: Jun 2013
Posts: 10
|
Re: Help,Engine Starts no movement 1992 Gas CCar
Hello Again,
Should I remove the ground wire on the rpm limiter and see what happens? 1992 club car |
06-11-2013, 03:12 PM | #18 |
What the ....?
Join Date: Jan 2007
Location: N.E. Wisconsin
Posts: 14,901
|
Re: Help,Engine Starts no movement 1992 Gas CCar
It wouldn't hurt! it's a cheap easy way to find out if the limiter is to blame...
Just make sure that you remove/disconnect the ground, and not cut it! |
07-01-2013, 11:10 PM | #19 |
Not Yet Wild
Join Date: Jun 2013
Posts: 10
|
Re: Help,Engine Starts no movement 1992 Gas CCar
Hello Again,
First,thank you all for the help. My last questions was: "Should I remove the ground wire on the RPM limiter and see what happens?" Well i finally did that and it runs like a charm. Will i kill the engine running it this way ? Again Thank you |
07-02-2013, 06:30 AM | #20 |
What the ....?
Join Date: Jan 2007
Location: N.E. Wisconsin
Posts: 14,901
|
Re: Help,Engine Starts no movement 1992 Gas CCar
As long as your governor is set to factory specs, (13 or 14mph on flat ground) you should be o.k.!
If you were to you run down a long, steep hill with the GO pedal mashed to the floor board, you might run into a problem! I'm glad you got it running! |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
engine starts when key tuned on | Gas EZGO | |||
Engine rarely starts. | Gas EZGO | |||
1992 feels like it starts in 3rd gear? | Electric EZGO | |||
1992 CC Engine Rebuild | Gas Club Car | |||
Micro switch information 1980 model CCar | Electric Club Car |