98 TXT electric ezgo won't run solenoid not clicking

[Yulee82]

My cart started having intermittent problems when hitting accelerator it wouldn't go but after pushing pedal several times it would go. Now it has completely stopped and don't hear a click from solenoid. Connected red lead from meter to terminal #2(with red wires) and black lead to negative post and pushed accelerator and don't get anything. I also tried leaving red lead on terminal #2 and putting the black lead on the positive post on first battery and I get 38volts. Then connected black lead to terminal #1 and the red lead to positive battery terminal and before hitting accelerator I get 38volts after hitting accelerator there's no change. Can take a short piece of #6THHN and connect from #2 post(with red wires) and jump to positive post on #1 battery and the solenoid clicks. Any HELP will be greatly appreciated!!

[rib33024]

Check for pack volts on the small red/ white/red wire coming out of the back side of the charger plug on the cart. Under the seat. It's called a reed switch. And check the micro switch in the go pedal box under the floor mat, little box right behind the go pedal

[scottyb]

The original problem description sounds alot like a micro switch failing = going going gone. There is one on the F&R with red and blue wires and one in the pedal box with red and green. Both need to be working......

[Yulee82]

Thanks for the help!! I went to check reed switch and realized that the red wire coming off of the back of charger plug wasn't connected to anything. I didn't see any type of switch but the red wire coming off of the back of charger plug had a female wire connector and there was a male wire connector on a red/white wire (that went to forward reverse switch)that was sitting close by so I connected them and we were off and running. Thanks again!

[halftimef]

I'm having the same problem I have a red wire with 36 volt but can't find where to connect any help if you could take phone pic and send it to 214-957-2020 thanks ken