E-Z-GO TXT48 2010+ Wiring Diagram

[rib33024]

Originally Posted by BobBoyce

I wanted to add this to the sticky for wiring diagrams, but the post was closed...

Added to the sticky

[BobBoyce]

Originally Posted by rib33024

Added to the sticky

Thank you. I think this was the TXT48 diagram that everone had been looking for. I could find nothing modern enough, so I sent a request to Textron. I was sent this by Textron in response to my request. I felt that it should be shared.

[BobBoyce]

Originally Posted by mjroman20

24v on 5&9 negative on the B- tab

That works good, thank you. I still needed the run/tow switch circuit switchable to access certain advanced features.

[BobBoyce]

The connectors arrived, so I made up a simple cable to allow benchtop programming of the 1206HB-5201 controllers used in the 2010 and later TXT48 carts. I'll apply power to B+ and B- on the controller, and use the cliplead connector as the run/tow selection... connect it to B+ for run and unhook it for tow.

[Dan33Klein]

Is this to do programming with the ezgo diagnostic tool?

I’m assuming this just allows you to do it outside of the cart?

[Dan33Klein]

Bob,

I don’t know if this diagram could help you or anyone else.

It is out of the service manual 2010+ where yours came from.

[BobBoyce]

Originally Posted by Dan33Klein

Bob,

I don’t know if this diagram could help you or anyone else.

It is out of the service manual 2010+ where yours came from.

I have the 2010+ TXT48 service manual now, and that diagram as well. I'm sure that others will need it, thank you for posting it.

[Dan33Klein]

No problem!

[BobBoyce]

The Personality Selector function of the Mode Lock 3 keyswitch version...

http://www.cartsunlimited.net/mode-l...-controls.html


can be wired to the 2 Personality Selector inputs (Pins 4 and 11) of the Curtis 1206HB-5201 factory controller used in the 2010 and newer TXT48 carts. It will only give default as N, and access to 2 of the 3 additional Personality Modes that are programmed.

Bob

[acrosteve]

Would you have more detail on the charging receptical wires? My cart has a small two conductor cable coming from it that is no longer connected to anything.

Thanks