|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
01-27-2019, 03:57 PM | #21 | |
Not Yet Wild
Join Date: Dec 2016
Posts: 65
|
Re: Finished Wiring but will not work (with video)
Quote:
Do you by chance know where I can buy a new controller connector/pins? Not sure I need the pins but I definitely think the connector is an issue. I hadn’t gotten to mess with it since my last message. Well this time I actually got to take it out of the garage and it’s acting funny. Really slow and keeps losing power. Hooked the controller to the computer so I could monitor it. If I run the throttle at 40% it is fine. If I go over that the cart gets jerky and eventually seems to lose power then regain some back. I was watching the voltage on the computer and had 49+ at the controller but while driving it never went over 30 volts at the motor itself. I was worried the Potentiometer wasn’t any good but watching it on the computer it see’s it go from 0% throttle all the way to 100% range as I press the pedal all the way down. At one point on the test ride I lost complete power and had to mess with the connector on the controller to get it working again. Doesn’t seem to be snapping in all the way. Sent from my iPhone using Tapatalk |
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-27-2019, 05:45 PM | #22 |
Gone Wild
Join Date: Feb 2015
Location: Quad cities
Posts: 334
|
Re: Finished Wiring but will not work (with video)
Try del city for connectors
|
01-27-2019, 06:37 PM | #23 |
Gone Wild
Join Date: Apr 2017
Location: SE TN
Posts: 2,217
|
Re: Finished Wiring but will not work (with video)
If you have a Wal-Mart close by get you a can of this stuff and spray the health out of that connector. CRC 5103 Quick Dry Electronic Cleaner - 11 Wt Oz.
https://www.walmart.com/ip/CRC-5103-...SABEgIXV_D_BwE |
01-27-2019, 07:48 PM | #24 |
revolutiongolfcars.com
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 10,224
|
Re: Finished Wiring but will not work (with video)
Neal, I'm not sure where it can be purchased but I'll look around. I know Sergio posted a link on here before for it. I'm sure he'll see this post and share it again if I can't find it first.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Will this wiring work? | Electric golf carts | |||
Installing 48V-12V reducer in cart with factory wiring harness, How do it work??? | Electric EZGO | |||
Video of finished product | Electric Club Car | |||
Wiring turn signal to only work when key is on | Electric EZGO | |||
Finished wiring but then!!!! | Big Block Talk! |